Are Oil & Gas Producers Fracking Wells at Depths That are Too Shallow?

Photo of Paul Ausick
By Paul Ausick Updated Published
This post may contain links from our sponsors and affiliates, and Flywheel Publishing may receive compensation for actions taken through them.

Drilling Rig
Thinkstock
Most people believe that the depths at which oil & gas producers drill and fracture wells exceed a mile or more below the earth’s surface. A new study reports that about 16% of wells were fracked at depths less than a mile below the surface–and sometimes much less.

The study was completed by Stanford’s Robert Jackson and colleagues and published in the “Environmental Science & Technology” journal. The researchers analyzed fracturing depths and water use for approximately 44,000 wells reported during the period between 2010 and 2013.

The average well fracking depth in the U.S. is 8,300 feet, but 6,900 (16%) were fracked at less than a mile below the surface and 2,600 (6%) at less than 3,000 feet. The researchers reported 850 wells in Texas, 720 in California, 310 in Arkansas, and 300 in Wyoming that were fracked at less than 3,000 feet.

Nationally the average amount of water used per well was reported as 2.4 million gallons. Leading water users were Arkansas (5.2 million gallons), Louisiana (5.1 million gallons), West Virginia (5 million gallons), and Pennsylvania (4.5 million gallons).

Some 2,000 wells shallower than one mile and 350 wells shallower than 3,000 feet were fracked with more than 1 million gallons of water. This practice was most common in Arkansas, New Mexico, Texas, Pennsylvania, and California. The researchers noted:

Because hydraulic fractures can propagate 2000 ft upward, shallow wells may warrant special safeguards, including a mandatory registry of locations, full chemical disclosure, and, where horizontal drilling is used, predrilling water testing to a radius 1000 ft beyond the greatest lateral extent.

The study calls into question at least in some cases the oil & gas industry’s claim that fracking occurs at depths so far below the water table as to make virtually impossible for contaminants to enter the water supply. A study released last year by Jackson and others, that oil & gas drillers used a production method called acid stimulation and hydraulic fracturing to drill wells near the Pavillion, Wyoming, gas field that contains both natural gas and sources of drinking water.

In 2011 the U.S. Environmental Protection Agency (EPA) noted the shallowness of the some wells in the Pavillion field. Fracking occurred at one well at a depth of about 1,200 feet. Some domestic and stock wells are as shallow as 800 feet.

ALSO READ: The 10 Most Oil-Rich States

Photo of Paul Ausick
About the Author Paul Ausick →

Paul Ausick has been writing for a673b.bigscoots-temp.com for more than a decade. He has written extensively on investing in the energy, defense, and technology sectors. In a previous life, he wrote technical documentation and managed a marketing communications group in Silicon Valley.

He has a bachelor's degree in English from the University of Chicago and now lives in Montana, where he fishes for trout in the summer and stays inside during the winter.

Featured Reads

Our top personal finance-related articles today. Your wallet will thank you later.

Continue Reading

Top Gaining Stocks

CBOE Vol: 1,568,143
PSKY Vol: 12,285,993
STX Vol: 7,378,346
ORCL Vol: 26,317,675
DDOG Vol: 6,247,779

Top Losing Stocks

LKQ
LKQ Vol: 4,367,433
CLX Vol: 13,260,523
SYK Vol: 4,519,455
MHK Vol: 1,859,865
AMGN Vol: 3,818,618